I have a dining room, very small and have been trying to do for a long time to deal with it, as well as access to the courtyard. I wanted to hear a coffee, but had a very small budget. Then one day my neighbor was the thought of a great idea. He had an old solid wood table that do not use anymore. He asked me if I thought we could cut in half and a wall mount style bar table out of it. I said yes, we can, and I take the other half. We have cut in two,half of the long side. We were both able to do a wall above the table / pub table from him. My neighbor will gather for their original height tables and the standard is already sitting in their seats.
My husband had received a lot of chairs to several large, dark forest, a pub. So I have about 10 cm in length to the legs by cutting a board 4 “x4″ size is required, the crunch game leg. I found a place to assemble the chairs and colorfulthe table and legs. This gave us the perfect little table, and some further interest in our small dining room.
You can easily do the same with an old table you sit on, or you can buy from a garage, selling real estate or a second hand shop. Measure the center of the table and with a carpenter’s square to make a straight line all the way through the center of the table. He left the table at the same time that you have to cut you want a screwBrett has been said about the lower end of the table, along with the saws. Make sure that each binding. Even before looking at sight, check to see if there are staples or screws so, and perhaps the blade to break or jump. Remove any metal which is in line with the line saw. Then on top of the table was a piece of tape on both sides of the perforation. This will help keep the table fragmentation during cutting. Remove the tape and lightly sandedlower edge of the cut.
To mount the board on the wall, the amount of the final table measured from the floor to the table. Then measure from the ground up to this amount on the wall and mark with a pencil. Take a level and a straight line along the length of the table. So a standard 2 “x4″ mount (cut a few inches shorter than the length of the table), on the line marked on the wall. Use nice long wood screws and be sure to go to the wall studs. L ‘Pin pin found with a finder that will find available cheap at their local store. It ‘a nice tool to have around.
Remember to always try out, think outside the box. One can, after so much life and interest to your home and can be carried out on a very small budget.
No related posts.